In the industrial production process, steam is needed in many places, whether it is high-temperature cleaning of industrial equipment, such as cleaning of milling machines, cleaning of CNC machine tools and foundry equipment, and cleaning of injection molding machine tools.
Mechanical and electrical devices, as well as pneumatic, hydraulic and other components can be cleaned using steam in a very short time. Cleaning of oil, grease, graphite or other stubborn dirt can be easily solved with dry steam, and high-temperature disinfection can also be performed. In many cases the use of electrically heated steam generators can completely replace expensive dry ice blasting methods.
Electrically heated steam generators are widely used in industrial production. They have fast air output, high thermal efficiency, are easy to use, and the power can be adjusted according to needs. They can meet needs without wasting corporate resources, and are favored by major enterprises! Large enterprises will use electric heating steam generators for disinfection systems, and small enterprises can use them for cleaning. The electric heating steam generator can perform high-temperature cleaning and disinfection of pipelines. It is highly efficient, energy-saving and environmentally friendly, with no emission pollution and meets the national emission requirements for general factories.
Precautions for use·
1. Try to use purified soft water. If there are sand, gravel and impurities in the water, it will damage the electric heating pipe, water pump, and pressure controller. Blockage of the pipes can easily cause loss of control. The liquid level controller can easily malfunction due to accumulation of dirt. Places with poor water quality must install purifiers. Water dispenser to ensure service life and intact machine performance.
2. The furnace must be drained once a week to avoid excessive accumulation of dirt and clogging of pipes. The liquid level controller, electric heating tube, furnace, and water tank should be maintained and cleaned once a month to ensure normal operation and extend service life.
3. Before connecting the water inlet pipe of the water tank, the water pipe must be flushed and drained once to prevent sand, gravel, iron filings and other debris from entering the water tank and flowing into the water pump, causing damage to the water pump.
4. Pay attention to the flow of tap water when using it for the first time and when adding water in the middle. It is strictly forbidden to prevent the water supply from affecting the quality and life of the water pump.
5. The generator may have difficulty adding water due to air in the pipe. In this case, you should open the lower door panel, install a bleed screw on the water outlet connector of the high-pressure vortex pump, turn it counterclockwise 3-4 times, wait until some water comes out, and then tighten the bleed screw.
6. If the shutdown time is too long, before use, turn the water pump several times by hand, then turn on the power and start working.
7. Steam pressure control, the factory control is within 0.4Mpa. Users are not allowed to increase the pressure control by themselves. If the pressure controller is out of control, it means that there is a blockage in the input steam pipe of the pressure controller and must be cleared before use.
8. During loading, unloading or installation, do not place it upside down or tilted, and water or steam cannot enter the electrical parts. If water or steam enters the electrical parts, it will easily cause leakage or damage.
Post time: Nov-10-2023
