Steam is widely used in intelligent daily life, so what should we pay attention to when using gas steam generators in winter? Today, I, a gas steam generator manufacturer, will take us to learn more about it!
If we are using liquefied petroleum gas, we should pay attention to the problem of insufficient gas supply due to low temperatures in winter, resulting in low vaporization quality changes in the cylinder. Since the temperature is relatively low in winter, the indoor and outdoor temperatures will be below zero, so we need to drain the water pump after blowing the boiler pipe to prevent the remaining water from freezing and cracking the water pump. Then before turning off the gas steam generator, first turn off the gas valve and then turn off the power supply.
If the gas steam generator is not used for a long time, remember to fill the heating furnace with water to prevent it from rusting. The gas inlet pressure cannot exceed 4 kPa (a kPa meter must be installed in front). The burner should be fired 4 times in a row. If it still cannot ignite, please stop for more than ten minutes before starting again.
When starting the steam generator, first open the bolt and then the power supply, gas and then the electric start button; to turn off the equipment, first turn off the stop button and then the power supply, and then close the gas valve. In addition, the steam generating granular steam generator must be sewed in time after use every day, the liquid level meter sewage and the furnace sewage must be drained, and the pressure controller does not need to be adjusted at will.
Secondly, the automatic softened water processor should add granular steam generator salt regularly (about 30 kilograms each time, about once every half month), and the input voltage of the control box should not exceed 240 volts. If the water quality is not good, , please add descaling agent for about three months to carry out scale cleaning.
Gas steam generator manufacturers indicate that gas steam generators are a common type of steam generator and a relatively common gas expansion equipment. The gas steam particle steam generator does not have a centrifugal air phase and a blower motor. Compared with traditional coal-fired steam boilers, its noise will be smaller. The gas steam generator can achieve fully intelligent automatic control. The centrifugal pump can control water replenishment, pressure and temperature. It can start automatically as long as there is ice, electricity and gas. The gas steam generator has a built-in smoke heater, which can greatly reduce the temperature of the smoke exhaust system, so that the heat can be better digested and absorbed.
Post time: Dec-11-2023
